|
The Mad PSI windshield wiper cowl was designed to be a complete
bolt-on replacement for the stock windshield wiper cowl. Our wiper
cowl is a cleaner and more unique alternative to the 1980s cheese
grater style OEM windshield wiper cowl.
•
Can I use the stock screws?
For the carbon fiber
windshield wiper cowl there are two screws at either end. The stock
one will be too short, you will need use longer screws than the
stock ones. All the other stock screws can be used. The two screws
you will need to get can be found at any hardware store such as Home
Depot, Orchard Supply, or Ace Hardware. Here are the specs of the
screws you need:
Screws you need for windshield wiper cowl:
Orchard Supply Hardware(OSH) part # 9216987
Pan head Drill point Tapping screw - Phillip
B-1Bx1"
•
What materials will the wiper cowl be available in?
Carbon fiber.
•
Can I pick up my order to save
money on shipping? Can I send my own shipping company?
Yes. Windshield wiper cowls will be stock in San Jose,
California. Please email to schedule an pick-up appointment.
• How are orders done?
There are two methods of placing your order.
(1) Orders are done by clicking on “add to cart” at the link
provided below. Our shopping cart allows you to make a payment via
Paypal balance, credit card, or bank account.
or (2) Money order or cashier's check.
Click here for information regarding money order or cashier's check
orders.
•
I am interested in the
Type B carbon fiber vented hood, the carbon fiber engine lid, and
the carbon fiber trunk, etc. Can I get some sort of "packaged deal" if I
order all of them?
Yes. Visit our
weight reduction
page for more information.
•
When will the group buy be active?
The group buy is active as of right now.
•
Will there
be pre-drilled holes?
There are four points where the wiper cowl needs
to be screwed in. The top two corner points above the hood are
pre-drilled. The bottom two corner points below the hood are
not pre-drilled, because the condition of your car may throw off the
alignment of the windshield wiper cowl. It is best to have a
qualified body shop install the wiper cowl.
•
How is gen 2 different from gen 1?
Gen 2 will have pre-drilled holes on the top two corners, the carbon fiber will be visible
below the hood as well (i.e., "full" carbon fiber), and it is
approximately 0.5lbs lighter in weight.
|
/Madpsi.net%20-%20Pouya's100%25CFVentedHoodandCFWiperCowl1.jpg)
